nighthawksetup

HOME
NETGEAR NIGHTHAWK EXTENDER SETUP
NETGEAR GENIE SETUP
+1 516-320-8459

Re.Rockspace.local Setup Challenge: Expert Tips for a Professional Setup

The Rockspace WiFi extender setup functions as a repeater, boosting signal strength and preventing dead spots. The primary frequency band used by the Rockspace WiFi extender is 2.4 GHz, which provides full signal coverage and 300 Mbps transfer speeds. Install a Re.Rockspace.local setup dual-band wifi extender to strengthen your home network by increasing the wifi signal’s speed and range. To expand the signal, just click the WPS button on the router, and the connection will be established quickly. As such, the device contains a reset button that can be used to set the WiFi extender back to what it was when it was originally manufactured.

New Extender Setup

Rockspace Wifi Range Extender Setup Manual Guide

  • Connect to the network of the Rockspace WiFi extender login by plugging it in.
  • Launch a web browser and type rockspace.local setup or ap.setup.
  • Use the default login information.
  • To choose and expand your WiFi network, adhere to the on-screen directions.
  • If necessary, apply the settings and watch for the extender to reboot.
  • To make sure WiFi is covered in large regions, check the strength of the signal.

 

Note: If you need any assistance regarding your Netgear wifi extender, get in touch with us via the chat button you see on the bottom right corner of this page.

Rockspace Extender Setup WPS Guide

How do I login to Rockspace WiFi Extender ?

  1. Place the Rockspace WiFi extender next to your router after plugging it in.
  2. Press WPS the button for .
  3. Press the WPS button within two minutes.
  4. Await for the extender’s WPS LED to solidify and cease blinking.
  5. If you need better coverage, move the extender.
  6. Now your Rockspace WiFi extender is ready to use WPS setup.
  • Connect to the WiFi network of the Rockspace extender.
  • Launch a web browser.
  • Enter ap.setup instead of rockspace.local.
  • If asked, enter the default password and username.
  • Go to the login screen.
  • Right now, Rockspace WiFi Extender is signed in for you.

 

How do I update the Rockspace WiFi Extender firmware?

  • Get the most recent firmware by visiting Rockspace’s official website.
  • Link into the WiFi network of the extender.
  • Launch a web browser and type rockspace.local or ap.setup.
  • Go to the settings page of the extender.
  • Go to the area for firmware updates.
  • Upload the firmware file that you downloaded.
  • To finish the update, follow the on-screen directions.
  • When the update is finished, wait and, if necessary, reboot the extender.

 

Rockspace Extender Reset Process

  • Find the Rockspace extender’s reset button.
  • Hold the reset button for 10 to 15 seconds.
  • When the LED lights begin to blink, release the reset button.
  • Await the reboot and factory reset of the extender.
  • Adjust the settings of your extender as necessary.
  • A successful reset of your Rockspace WiFi extender took place.