nighthawksetup

HOME
NETGEAR NIGHTHAWK EXTENDER SETUP
NETGEAR GENIE SETUP
CONTACT US

Netgear EX6410 Setup

When paired with the router, the Netgear EX6410 setup expands the internet’s reach throughout the entire house without compromising speed. In order to benefit from this, you must complete the Netgear EX6410 extender setup. Learn how to carry out the installation procedure and about other relevant subjects by reading the next sections.

NEW EXTENDER SETUP
Netgear EX6410 Setup

Netgear EX6410 Wifi Extender Setup Manual Setup

Netgear EX6410 Setup via wps button

  • Close to your router, plug in the Netgear EX6410.
  • Link a computer or a mobile device to the extender’s WiFi network.
  • Launch a browser, then go to mywifiext.net setup.
  • Enter the password and username to log in: password.
  • Choose the WiFi network you want to expand, then type the password.
  • As prompted, adjust the settings on your extender.
  • After saving your configuration, move the extender to the desired spot.

 

  • Connect the wall sockets to the EX6410 extender.
  • Press the Power button gently.
  • Press the WPS button.
  • The WPS LED will blink in a short while.
  • On the router, click that exact button.
  • Once your gadget has had enough time to adjust, move it.

 

Note: If you need any assistance regarding your Netgear wifi extender, get in touch with us via the chat button you see on the bottom right corner of this page.

Netgear EX6410 WiFi Range Extender Login Steps

Netgear EX6410 WiFi Extender Update Firmware

  • Verify that the Netgear EX6410 has been turned on and plugged in.
  • Link a gadget to the built-in WiFi network of the EX6410.
  • Open a browser, then navigate to mywifiext.net login.
  • Put “password” as the password and “admin” as the username.
  • You can access the extender’s settings by clicking the ‘Login’ button.
  • If this is your first time logging in, follow the on-screen steps for initial setup.
  • You will immediately be able to access the dashboard again.
  • You can now change the settings or see how your extender is doing.

 

  • Join the network of your Netgear EX6410.
  • Go to mywifiext.net setup in the address bar of an open browser.
  • Enter your admin credentials to log in.
  • Proceed to Settings and choose Firmware Update.
  • To find out what updates are available, click Check Online.
  • Click Update to start the process if there is an update.
  • Please do not disconnect the power supply while you wait for the firmware to download and install.
  • The extension will automatically reboot after the update is finished.

 

Netgear EX6410 Wifi Extender Setup

Netgear EX6410 Reset Process

  • At the side of your Netgear EX6410, look for the Reset button.
  • Using a paperclip or other such item, press and hold the Reset button for ten seconds.
  • Remove the button the minute the LED lights start to flash.
  • Await the complete reboot of the extender and the settling of the LED.
  • Now, the EX6410 is back to its original factory options.
  • Restart your device to the default WiFi network on the extender.
  • Use www.mywifiext.net setup to adjust your extender’s settings as necessary.