Netgear WN3000RP Setup

The Netgear WN3000RP Setup is a WiFi network extender that can be used across the house to help remove internet dead zones. However, this won’t happen until the installation is complete and the extender is connected to the router. You can find all the information you need to know about this particular range extender on this page. This suggests that there are two methods for learning about Netgear WN3000RP extender setup : how to reset the device and how to update the firmware of the extender by logging in.

Netgear WN3000RP Setup

WN3000RP Installation via Manual Method

  • Keep your extender and router in the same room, to start.
  • Unplug your router and use an RJ45 cable to connect the LAN port of the router to the Internet port of the extender.
  • Connect your PC to the range extender now using a LAN cable.
  • Turn on each of the connected devices. Router > extender > PC is the proper order.
  • Enter the IP address of the extender in the URL bar of an open web browser.
  • When you hit the “Enter” key, your extender login screen will appear.
  • After entering the extender’s admin credentials, click Log In.
  • It will show the New Extender Setup page.
  • Choose the mode in which you wish to use the extender after that.

Note: If you need any assistance regarding your Netgear wifi extender, get in touch with us via the chat button you see on the bottom right corner of this page.

How to Set Up Netgear WN3000RP via WPS Method?

How to Log in to Netgear WN3000RP Extender?

  • Make sure your router and range extender are located in the same room.
  • Turn on the WiFi extender and router for your system.
  • Locate and push the WN3000RP’s WPS button.
  • Next, press the WPS button on the router.
  • It will illuminate the 2.4GHz WPS LED on your WN3000RP.
  • To connect a 5GHz WPS device, follow the preceding two steps again.


  • Verify that every cable connection made to the extender is in working order.
  • Now turn on your PC and attach it to Netgear_ext.
  • Launch a web browser and enter or
  • Hit the Enter key.
  • The range extender’s login page will be displayed to you.
  • Enter your password and a valid username here.
  • Click on Log In.


WN3000RP Installation via Manual Method

Steps to Update WN3000RP Firmware

When and How to Reset Netgear WN3000RP?

  • Find the repair option on the status page after logging into the extender.
  • Select the option for firmware updates.
  • Click on Check Now.
  • The firmware on your extender will be updated if one is available.
  • In the event that the extender needs to be updated, adhere to the on-screen directions.


If the extender is not functioning at all, it needs to be reset if it is not working correctly or if you have forgotten the admin password. To reset the extender, follow the instructions below.

  • On the extender, locate the reset button.
  • Use an oil pin to help press it.
  • Press and hold it for 15 seconds.
  • The extender on your device will reset.