Unable to connect to the Netgear WiFi range extender EX6120 (fixes)

One WiFi device that improves your home network is the Netgear EX6120 wifi range extender. In concert with the router, it extends the signals to areas where the router’s signals are unsuccessful. You must apply a few typical fixes to the Netgear wifi range extender EX6120 if you run into issues with it not connecting to your local network. Yes, your problem will be fixed by these solutions.

Moving and reconnecting

Employ an Ethernet cable.

This issue often arises when the extender lies outside of the router’s range.
In this case, you must move the extender within the router’s range, connect, and set up the router using either
After placing the extender, locate the router’s WPS button and press it.
A few seconds later, press the extender’s WPS button. On both the router and the extender, a light started to blink.
When it becomes a solid light, the Netgear wifi range extender ex6120 is successfully

If at all possible, use an Ethernet wire to connect the extender to the router.
The method offers higher speed and dependability.
because the router and the extender are no longer colliding with one another.
Use it to set up the extender and router while using an Ethernet cable.
Choose the network of the router that you wish to extend by entering into the extender’s interface.

Reasons of this Issue

Correctly Reset

Low Signal Strength between the Satellite and Router
Poor Extender Placement or Signal Interference
Utilizing outdated firmware and incorrect configuration

Find the reset button placed on the extender’s back panel.
The EX6120’s factory reset button
Hold it for five to ten seconds.
a steady white.
If the reset occurs, repeat the Netgear EX6120 Setup step.

Conclusion

The blog post above explains various ways to fix the Netgear wifi range extender ex6120’s inability to connect to the router or the internet. I hope you find this site handy. Get in with our team if you’re facing issues.