Netgear EX6000 extender Setup

Before setting up the Netgear EX6000 extender setup, plug it into a power outlet close to your router. Join the NETGEAR_EXT network on a WiFi-capable device, then click to mywifiext.net setup in a web browser. Follow the setup wizard’s instructions to connect the extender to the current WiFi network.

Netgear EX6000 Extender Setup | Manual Method

Netgear EX6000 Wifi Extender Setup | WPS Method

Plug the Netgear EX6000 extender to an outlet next to your router.
Await the Power LED’s solid green turn.
Add your device to the extender’s built-in WiFi network, NETGEAR_EXT.
Open a web browser and enter mywifiext.net setup.
Either create a new account or use the default credentials.
Just follow these steps to connect the extender to your existing WiFi network.
Once setup, position the extender midway between the router and the area where WiFi is poor.
Reconnect your devices to the bigger network to boost coverage.

Plug the Netgear EX6000 extender into an electrical outlet and place it next to your WiFi router.
Make sure the extender is turned on as soon as the Power LED fixes.
Enter the WPS key on the EX6000.
For two minutes, press the WPS button.
As the WPS LED on the extender turns solid green, it implies the connection was successful.
The extender should be set between your router and the area with little WiFi signal.
Wait for a fresh connection to be made by the router and extender.
Connect your devices to the newly larger WiFi network.

Note: If you need any assistance regarding your Netgear wifi extender, get in touch with us via the chat button you see on the bottom right corner of this page.

How do I login to the Netgear EX6000 setup?

Netgear EX6000 WiFi Range Extender | Firmware Update

Plug the Netgear EX6000 extender in and turn it on.
Using the WiFi network that the extender has built in to connect your device.
In the address bar of your web browser, type mywifiext.net setup.
Enter the default username and password when given.
Use the setup wizard to change your extender’s settings.
After saving those choices, simply log out.

Plug the Netgear EX6000 extender in and turn it on.
Use the WiFi network that the extender has built in to connect your device.
In the address bar of your web browser, type mywifiext.net setup.
Enter the default username and password when requested.
Use the setup wizard to alter your extender’s settings.
After saving what you chose, completely log out.

Netgear EX6000 | Reset Process

Select the reset option for the Netgear EX6000 extender.
With a paperclip or other tiny object, click and hold the Reset button for around seven seconds.
Release the button when the Power LED starts to blink, indicating that the reset is in action.
It can take a few minutes for the extender to fully restart.
After the extender has been reset, modify its settings as needed.